#SPECTRE RF TOOLBOX CODE#

user_name: APN ID supplied by your mobile operator.

apn_name: APN name supplied by your mobile operator.

Replace the above SMS fields with the following information: The SIM card must be inserted into the unit before connection to the mains supply.Īfter connection to the mains supply, send the following SMS messages to the number of the previously inserted SIM card:Īfter replacing the generic fields with those of your operator, send the following SMS*:

#SPECTRE RF TOOLBOX CODE#

This configuration method requires the use of an active SIM card with a data option and a pin code that must be either “0000” or disabled.

Change the connection settings of the GPRS modem to the settings provided by your mobile operator.Ħ/ Restart the WebdynSun gateway using the new settings.ħ/ In the menu, click on the “installation” tab, followed by the “connection” sub-tab and start the connection.

If connecting via the GPRS network (Modem): Please note, all fields must be completed in accordance with the configuration of your local network.

Edit the WebdynSun’s IP parameters by assigning it a network-compatible address.

If connecting via the local network (Ethernet): There are two types of configuration: via the web interface or via SMS.ġ/ Go to the configuration page with the gateway IP address (default 192.168.1.12)ģ/ Select either the Ethernet or modem connection mode:

Connect: to launch the connection to the FTP server and load the configuration ( see section 3.1 : “ “connect” connection command.

Ftp: to configure the FTP server that will contain the concentration configuration ( see section 3.3 : “ “ftp” FTP configuration command”).

(see section 3.2: “ “apn” modem configuration command ) Text message configuration requires sending the following commands:

See section 3.1.2 : “ Configuration files ” for more details. The other fields can be left at the default values subject to the directories having been properly created beforehand. Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”. The parameters for the servers to be configured are at least the following:

This configuration is done from the “Modem” configuration page ( see section 3.2.2.4 : “ Modem ”). This configuration is done from the “Networks” configuration page ( see section 3.2.2.3 : “ Networks ”).įor a modem connection, the modem configuration must be correct before a connection can be set up.

For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. Start by establishing a connection to the concentrator by connecting to it to access the server configuration:Įnter the “ethernet” or “modem” connection type:įor an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration.

Folks who simply rote memorize can NEVER do that well and that's a large part of why they fail as engineers.There are two configuration solutions, using the web interface and using text messages: There is some rote learning required but you should have a good foundational of knowledge so that you can extrapolate/interpolate from the theory into specific situations. I get off on it and I'm happy to spend time exercising my mind with these.Įverything else you might do is just 'rote learning' which definitely will NOT carry you in RF. I mean, really like it as a form of play! I like crossword puzzles and sudoku much as I like math, for instance. It's a lot of math and you have to really like math however. Grok those and RF isn't really mysterious. So that's Maxwell's Equations, Lumped Model circuits, Transmission Lines, Antenna theory, and closely related fields. That's what defines or negates the 'black magic' of RF: Do you grok the math and physics? If you do, there is nothing 'black magic' about RF at all. Most of the 'basics of RF electronics' starts with the mathematics and physics of RF.

Spectre rf toolbox